Garage Door Springs Repair

The overhead garage door is equipped with torsion springs to facilitate it in opening and closing operations, regardless of whether the garage door swings up in one solid piece or rolls up in multiple sections. With the passage of time, these springs may lose their tension or break out which can be replaced or rewound easily. It is important here to understand that the danger involves in this work needs professional assistance. Do you want to get more details about garage door springs, Visit Here Right Now!!

Types of garage door springs:

As you know that garage door runs on the steel tracks connected to the walls of the garage. There are several types of garage door depending on the material with respective spring types like, torsion springs, extension springs, or a combination of both.

  • Swing-Up garage door: This garage door runs on the horizontal metal tracks which are mounted high on the walls of the garage. The steel tracks should be adjusted slightly down toward the back of the garage. The springs are attached on either side of the garage door frame and hooked to the bottom panel of the garage door. Even if the springs are good enough, it is worth inspecting around to find out loose components including screws, nuts, and plates which mount each other.
  • Roll-over garage door: In this category, the steel tracks are mounted in the curve shape from vertical to horizontal in order to roll the garage door up and back into the garage. In this category, torsion springs are used which are control through a cable and pulley system. These garage doors allow you to adjust the stress on your own by pulling on the cable and re-tightening the knots in order to increase and decrease the length of the garage door cables. 

Important note: It is good to remember that if your garage door has only one spring placed at the center, right above the garage door opening, it will give you severe injuries due to extreme pressure on them. Call a professional garage door expert rather than trying to fix it on your own.

Garage door spring repair services:

Even though replacing garage door springs is a challenging and risky project to handle on your own. If you feel up to the challenge make sure that new springs are the same size and diameter. You should be familiar with the winding bars. The store energy of winding springs can lead to dangerous injuries if you are not extremely careful.

There are many online tutorials available on the internet for garage door torsion spring replacement. But there are also some important points to keep in mind. First of all, close your garage door completely and disconnect it from the opener to stop the power supply. Place your wood ladder to one side of your garage door where you will have to work to avoid the way of the winding bars. Always keep a strong grip on the winding bars and then insert them into the holes of winding cones. Be careful and avoid over-winding the cone, it will make your garage door bouncy and under winding will make the operations harder.

Bottom line:

If you have any doubts about your capabilities, do not hesitate to consult a professional garage door technician to handle this project.